Side Holders for Fellow Ode Gen 2

Two small holders for the side panel of the Fellow Ode Gen 2. The brush holder keeps the Ode brush upright, bristles up, and the ring hook holds the spare catch-cup lid. Both stick on with the double-sided foam tape on their backs, with no tools. Matte black PLA; choose the full set or the brush holder only.

Support in English and six more languages
Designed and made by Black Tamp · all 57 products

A place for the brush and the spare lid

The Fellow Ode brush and the spare catch-cup lid tend to lie around on the counter. This set gives them a place on the side of the grinder: a brush holder and a ring hook that stick onto the flat side panel of the Ode Gen 2.

Brush always at hand

The brush holder takes the Fellow Ode brush upright, with the bristles up and clean. Its 17.8 mm bore fits the brush handle, and a slot in the front lets you see and grab it.

Spare lid on a hook

The ring hook holds the spare catch-cup lid by its centre hole, so the lid stays off the counter and right where you need it. The Black Tamp logo sits on the front of the hook.

Sticks on, no tools

Double-sided foam tape pads sit in a shallow pocket on the back of each part. Peel off the liner, press the part onto the flat side panel and it holds. No screws and no drilling.

Questions before you buy

Does it fit the Ode Gen 1? The set is made for the flat side panel of the Ode Gen 2, so we name only the Gen 2.
Do I need to drill? No. Both parts stick on with double-sided foam tape.
Are the brush and the lid included? No. The set holds the Fellow Ode brush and the spare catch-cup lid; neither is included.

Choose the right size

Full Set: the brush holder and the ring hook. This version is selected by default.
Brush Holder Only: the brush holder on its own, if you only want a place for the brush.

How to use it

Wipe the side panel of the grinder clean and let it dry.
Hold each part in place to choose its spot, the brush holder with its open slot facing out.
Peel the liner off the tape and press the part firmly onto the panel for a few seconds.
Stand the brush in the holder, bristles up, and hang the spare lid on the hook.

Materials and care

Both parts are 3D printed in matte black PLA, so they sit quietly next to the Ode's own black finish. Like any 3D printed part, they show fine layer lines on the surface. Wipe them with a dry or slightly damp cloth.