Pressure Gauge Mount for Cafelat Robot
A mount that holds the pressure gauge on the Cafelat Robot. Its 12.15 mm hex seat takes the 12 mm hex nut of the gauge fitting. It mounts with the double-sided tape in the box, or with an M5 screw through the hole at the back (screw not included). Matte black PLA.
- Support in English and six more languages
Black Tamp
Designed and made by us · 43 products
A mount for the gauge on the Robot
This Cafelat Robot pressure gauge mount holds the gauge on the Robot. A 12.15 mm hex hole takes the 12 mm hex nut of the gauge fitting, with 0.075 mm of clearance on each flat.
The mount is slim: 21.6 mm wide.
How it fits
The mount fixes with the double-sided tape that comes in the box. If you prefer a screw, there is a Ø5.2 mm hole at the back for an M5 screw; the screw is not included.
Materials and care
The mount is 3D printed in matte black PLA, and like any 3D printed part it shows fine layer lines on its surface.
PLA softens with heat, so wash it by hand in lukewarm water with mild dish soap and keep it out of the dishwasher.
What's in the box
- 1 × pressure gauge mount
- Double-sided tape
The pressure gauge, the M5 screw, the machine and anything else shown in the photos are not included.
Fits these machines
Specifications
Sizes and fit
- Fits
- Cafelat Robot
Build
- Mount
- 51.7 × 32.8 × 21.6 mm
- Mounting
- Double-sided tape, included
- Material
- Matte black PLA, 3D printed
Extras
- Hex seat
- 12.15 mm across flats, for the gauge fitting's 12 mm hex nut
- Screw hole
- At the back, Ø5.2 mm, for an M5 screw (not included)
- Care
- Hand wash in lukewarm water with mild dish soap, not dishwasher safe
- Brand
- Black Tamp
Reviews
No reviews yet. Be the first to write one.
Write the first review
Goes well with
Recently viewed
$12.00
Write the first review